We stock 45-degree standard plotter blades (GL9V) that are specifically engineered for use with Graphtec plotters and cutters* for use with "normal" vinyls/flex.
* NOTE: These are designed for full-width Graphtec plotter cutters, rather than the Silhouette/Craft Robo range
In addition, most of our customers opt for smart knives which are precision engineered for the specific plotter that they have. Changing blades can be time-consuming and intricate, especially blades that have springs, and blades can be easily damaged when being installed. However, our range of smart knives are encapsulated in a pre-cast holder and are pre-set to the required depth so that they can be used immediately (after a test cut). Based on this, we also stock ""Normal"" vinyl/flex (GSK09V) (with a Blue cap) and Fine Detail/Flock (GSK09F) (with a Red cap) smart knives for Graphtec plotters and cutters.
CUTTING TIP: When you insert a new blade or Smart Knife, you should always check your plotter settings and do a test cut before cutting your intended design.
Still Looking For More Information?
Still looking for answers? If you're new to heat pressing, or are looking for advice and support, take a look at our Frequently Asked Questions to see if you can find the answer that you're looking for.