In addition to the standard Hotronix lower platens, we also offer a wide selection of quick-release interchangeable lower platens specifically designed for the Hotronix® MAXX and Auto-Open Sprint cap presses which are all produly made in the USA, enabling the heat press operator to apply onto a wider range of caps with far greater ease.

6cm x 8cm (2.4" x 3.2") Lower Cap Platen (Small) For Hotronix Cap Presses

The 6cm x 8cm (2.4" x 3.2") Cap Lower Platen (Small) is designed for applying onto childrens caps and hats, along with caps that are traditionally difficult to fit on even the Low Profile cap platen.

Find out more about 6cm x 8cm (2.4" x 3.2") Lower Cap Platen (Small) For Hotronix Cap Presses

7cm x 16cm (2.8" x 6.4") Lower Cap Platen (Low Profile) For Hotronix Cap Presses

The 7cm x 16cm (2.8" x 6.4") Cap Platen (Low Profile) is perfect for caps and hats that have small printable area on the front and is ideal for visors.

Find out more about 7cm x 16cm (2.8" x 6.4") Lower Cap Platen (Low Profile) For Hotronix Cap Presses

7.5cm x 14.5cm (3" x 5.8") Lower Cap Platen (Low Crown) For Hotronix Cap Presses

The 7.5cm x 14.5cm (3" x 5.8") Cap Platen (Low Crown) is designed for use with caps and hats that have a low crown or medium-sized printable surface.

Find out more about 7.5cm x 14.5cm (3" x 5.8") Lower Cap Platen (Low Crown) For Hotronix Cap Presses

9cm x 16cm (3.6" x 6.4") Lower Cap Platen (Standard) For Hotronix Cap Presses

The 9cm x 16cm (3.6" x 6.4") Cap Platen (Standard) is the default cap platen that is shipped with all of our cap heat presses.

Find out more about 9cm x 16cm (3.6" x 6.4") Lower Cap Platen (Standard) For Hotronix Cap Presses

10cm x 16cm (4" x 6.4") Lower Cap Platen (Full Profile) For Hotronix Cap Presses

The 10cm x 16cm (4" x 6.4") Cap Platen (Full Profile) is designed for caps and hats that have full-front crowns, and is ideal for modern, snap-back caps.

Find out more about 10cm x 16cm (4" x 6.4") Lower Cap Platen (Full Profile) For Hotronix Cap Presses

10cm x 22cm (4" x 8.8") Lower Cap Platen (Over-Sized) For Hotronix Cap Presses

The 10cm x 22cm (4" x 8.8") Cap Platen (Over-Sized) is designed for oversized caps and other headwear with large printing surfaces.

Find out more about 10cm x 22cm (4" x 8.8") Lower Cap Platen (Over-Sized) For Hotronix Cap Presses

Badgers of Blackpool
60 Kenilworth Gardens
Blackpool, Lancashire
FY4 1JJ

Tel: 01253 349917

Email: This email address is being protected from spambots. You need JavaScript enabled to view it.